LED phosphor material

Contact by phone +81-3-5821-7455

LED phosphor material

Introduced models

Introduced model: ARV-310LED

Production Technology Development Division

When mixing epoxy or silicon resin and filler or phosphor materials during the sealing process, we used to manually mix for about 10 minutes by hand and then deaerate with a vacuum deaerator. However, manual mixing made the result vary depending on the operator, and it was difficult to make the material even. Also, if deaerated with the vacuum deaerator, bubbles would blow up and more time was required, which made the mixed filler and phosphor material separate and precipitate again, rendering it difficult to use. To address the problems above, we introduced your vacuum mixer THINKY MIXER ARV-310LED. After introduction, being able to mix and deaerate at the same time, we cut back the processing time significantly. Also the important benefit of introducing THINKY MIXER was that mixing status is stable, constant, and even.

Contact by phone +81-3-5821-7455

Back to top